![]() you will need print support for that one. Use m3x8 to mount it on the orbiter 1.5 mounting holes.ĭec20: Added prototype of new BMG mount using the groove mount. ![]() And a second in two pieces, no print support, held together with two M3x8. Single print version with print support needed. Based on a clone BMG so not sure if the locked version will work on all.ĭec28: Reorganized files in zips and folders, should be more intuitive nowĭec 28: Updated dragon rigid mount with M6 pneumatic fitting thread, for bowden setup.ĭec22: Redesigned BMG groove mount added with orbiter1.5 mounting holes. "unlocked" version that can rotate 360 like before, locked version with motor facing the front, and locked version with motor facing the left side. (Not compatible with UHF version as it's too tall).ĭec29: updated BMG orbiter 1.5 mount, larger platform, and heat inserts version for the 2 pieces. Rapido M2.5x8, would take exactly 8mm screws, so added 0.6mm of tolerance to give little roomįor ender3/pro/v2 CR10 added a no direct drive version with swappable probe and one with no probeĭec29: added step by step instruction with picturesĭec 29: Phaetus Rapido HF (ender3/pro/v2 cr10 and hermitcrab mount) updated, installed and working. Jan 8, 2022: I was pointed out that the rigid mount for the dragonfly BMO could only take M2.5圆, So I added a version of the mount for M2.5x8, and maximum M3x8 to bind the two printed part (M2.5圆 version will remain) Make sure to set the correct BLtouch offset and mesh min/max to avoid crashing your print head (values are further below)įeb 10, 2022: Mars orbiter files are now free thanks to my Patron supporter on - and a huge thank you to everyone else who purchased it here.īeefed up the BLTouch cable tidy prongs, should not break as easily (hopefully) Slice Engineering copperhead (unconfirmed), Phaetus Rapid HF (unconfirmed), stock hotend, dragon (rigid mounted), dragonfly BMS/BMO (rigid mounted), microswiss Direct drive.BLtouch, CRtouch, 12mm & 18mm probes (like EZABL).adxl345 mount (generic and adafruit one).hotend fan can be 40x20 or 40x10 ( 10mm spacer included in files ).orbiter extruder, sherpa mini, BMG, microswiss direct drive (may need tweaking), some self printed ones that attaches on the wheel axles.Can be used with or without a direct drive system (aka bowden setup).Thank to everyone who supported my work by purchasing it here and to my patreon supporter the Mars Orbiter files are now free ! Please consider supporting my work on Patreon ![]() It's superior in many ways thanks to everything I learned doing this one. Looks may be different but the fully functional beta of its successor called SaturnOrbiter is available if you become a patron ( you also get access to other shroud design I'm working on) (this is and always has been a public post for the instructions) STEP BY STEP installation with pictures:
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |